SMC Networks M8501 manual 2. Fault Symptom Codes, Message

TroubleshootingFault Symptom Codes (FSCs)

Table 6-2. Fault Symptom Codes

Message	FSC	ERP
Unknown	701E	C, G	Attempt to show detailed drive status of a
			drive whose type is unknown.
The SCSI response	701F	C, G	The command response from the SCSI
was not expected			task in a remote module was unexpected.
The Flash response	7020	C, G	The command response from the Flash
was not expected			task in a remote module was unexpected.
SCSI response not	7021	C, G	A command response was received from
matched to a known			a SCSI task, but the original command
command			opcode could not be determined.
Unexpected state after	7022	C, G	After successfully completing a
NonVolConfig cmd			NonVolCofigPut command, the current
			state of the save operation was unknown
Unexpected state after	7023	C, G	After successfully completing a
SCSI mode cmd			SCSIUpdateModeParameters command,
			the current state of the save operation
			was unknown.
Unexpected state after	7024	C, G	After successfully completing a
SCSI init cmd			SCSIInitcommand, the current state of the
			save operation was unknown.
Cartridge reject	8001	C, D, G The DLT drive failed to successfully load
recovery failed			a tape even after retries.
Drive Fan stalled	8002	C, D, G The fan in the drive hot-swap shoe is
			either not installed or has stalled.
Drive load did not	8003	C, D, G The drive failed to successfully load a
complete			tape.
Invalid drive was	8004	F	One or more installed drives are of a type
installed			either unknown or not supported in the
			current ACL personality.
LTO unmask drive	8005	F	The LTO drive unmask operation failed.
failed
LTO mask drive failed	8006	F	The LTO drive mask operation failed.
LTO unload drive (In	8007	F	The LTO drive failed to unload a cartridge
load retry) failed			during a load retry operation.
Is Drive Unloaded	8008	F	The LTO drive failed to return status when
Failed			being polled for unloaded state.
Orphan cartridge	9001	C, D, G The master module could not successfully
recovery failed			return an orphan cartridge to a slot
			location.
Master pass-thru opto	9003	C, D, G The master module opto sensor was not
failed			detected during the power-up pass-thru
			module inventory.

M8501 and M8502 ACL Tape Drive Installation and User’s Guide — 529972-001

6-11