Network > NAT Policies
265
SonicOS Enhanced 4.0 Administrator Guide
and activate the changes. For an example, see the screenshot below. Debug logs should only
be used for initial configuration and troubleshooting, and it is advised that once setup is
complete, you set the logging level to a more appropriate level for your network environment.
To enable log name resolution, go to Log > Name Resolution, choose DNS then NetBios from
the Name Resolution Menu drop-down list, and click on the Apply button in the upper right
hand corner to save and activate the changes.
Configuring NAT Load Balancing
To configure NAT load balancing, you must complete the following tasks:
1. Create address objects.
2. Create address group.
3. Create inbound NAT LB Policy.
4. Create outbound NAT LB Policy.
5. Create Firewall Rule.
6. Verify and troubleshoot the network if necessary.
To complete this configuration, perform the following steps:
Step 1 Create Network Objects -- Go to the Network > Address Objects page in the Management
GUI and create the network objects for both of the internal Web servers, and the Virtual IP (VIP)
on which external users will access the servers.