Sony AV-DV75 RECORDING Ahl AUDIO SOURCE, To F~Lay A Dvd Or Ld Recorded In Doliby Digital Surround

TO F~LAY A DVD OR LD RECORDED IN DOLIBY DIGITAL SURROUND

This receiver is equipped with the Dolby Digital decoder and has the DIGITAL IN (both OPTICAL and COAXIAL) terminals. When a DVD or LD player is connected to the DIGITAL IN terminal of the receiver, you can enjoy theater-quality audio right in your home when playing discs recorded in Dolby Digital Surround.

Before operation

Check that the TAPE MONITOR is not selected. If the TAPE MONITOR is selected, press the TAPE MONITOR button so that “TAPEOFF appears on the display,

1 Turn the FUNCTION to select the VIDEO 1 (VIDEO 2 or VIDEO 3) and press the DIGITAUANALOG/

BAIND button repeatedly until “DIGITAL” is displayed.

The DVD (LD) player connected to the OPTICAL (COAXIAL) DIG IITALIN terminal is selected as a source.

2 Start playing the DVD (LD) recorded in Dolby Digital Surround.

The ‘[DOLBY DIGITAL” indicator will light on the display when the bit stream of the Dolby Digital Surround comes in the unit.

To select the Dolby Digital Surround mode according to your speakers, see “SELECTING DOLBY SURROUND” on page 15.

mim

*While the TAPE MONITOR is selected and the TAPE MONITOR indicator turns red, “DIGITAL cannot be selected.

●When headphones are plugged in, the Dolby Digital Surround mode is automatically changed to “2chSTERE0 and the “2CH DOWNMIX indicator lights on the display.

Even if the DOLBY SURROUND button is pressed while the headphones are plugged in, the mode cannot be changed.

●This unit supports input signals of the Dolby Digital Surround bit stream and linear PCM whose sampling frequency is 32 kHz, 44.1 kHz and 48 kHz. The unit cannot play the DVDS whose sampling frequency is 96 kHz.

●When connecting some DVD player to the receiver through the DIGITAL IN terminals, noise maybe heard in the DVD operation: e.g. searching a disc, skipping a chapter.

RECORDING Ahl AUDIO SOURCE

1ENTER

TAPE MONITOR MULTIJOG

1 Select the program source to be recorded.

Turn the FUNCTION.

2Set the tape deck or MD recorder to the recording mode.

3Start the selected program source.

To monitor recorded sound during recording (where the connected tape deck is a three-head system)

Press the TAPE MONITOR button. “TAPEON” appears (onthe display for four seconds, and then the source name selected in step 1 comes back on. To cancel the tape monitor, press it again so that “TAPEOFF” appears.

m%f

●Any sound control system has no effect on recording (see

page 8).

✎Input sound through the DIGITAL IN terminals cannot be recorded. When recording the sound from the DVD, CID, Ml) or LD player, connect the analog AUDIO OUT terminals of the player to the corresponding AUDIO IN terminals of the receiver.

The sound will be recorded in 2 ch stereo.

●When recording audio sources by the MD recorder connected to the VIDEO 1/DVD/MD AUDIO OUT terminals, the selected video source (see page 11) should be V2 or V:3. Recording cannot be done while the VI (VIDEO 1) is selected and displayed on the window,

●Input sound from the tape deck connected to the TAPIE MONITOR IN terminals cannot be recorded.