Sony AV-DV75 manual Setting The Clock, Setting The Sleep Timer, 2 1,3, ENGLISH20

SETTING THE CLOCK

2 1,3

DIGITAUANALOG/f3AND

When the AC cord is connected for the first time, the clock on the display flashes.

Set the time as follows while the power is off.

1 Press the ENTER button on the main unit.

The display becomes a little brighter.

2 Turn the MULTI JOG to designate the hour and the minute.

The time advances by turning it to right, and decreases by turning it to left.

The DOWN or UP button on the main unit is also available. Press the button repeatedly. To change the time rapidly in 10-minute steps, hold it down.

3 Press the ENTER button on the main unit.

The clock starts from 00 seconds,

When the clock is set for the first time after purchase Everything on the display will clear.

This is because the power economizing mode of the unit is activated, and is not a malfunction.

The power economizing mode can be canceled. See page 7 for details.

To correct the current time

Press the POWER button to turn the unit off. Carry out steps 1 to 3 above.

To display the current time

Press the CLOCK button on the remote control. The clock is displayed for 4 seconds.

To switch to the 24-hour standard

While the power is on, press the CLOCK button on the remote control to display the clock. Then press the DIG ITA!JANALOG/ BAND button while the clock is displayed.

Repeat the same procedure to restore the 12-hour standard.

If the clock Clisplayflashes while the power IS off

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

SETTING THE SLEEP TIMER

2

1

UP!

DOWN

The receiver can be automatically turned off at a specified time.

1 Press the AIWA RECEIVER button.

2 Press the SLEEP button.

The unit will be turned off after about 60 minutes.

To specify the tilme until the power is turned off

Press the UP or DOWN button repeatedly within four secondls ❑ after step 2.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off Press the SLEEP button once. The remaining time is displayed for four seconds.

To cancel the sleep timer

Press the SLEEP button twice so that “SLEEP on the dlisplay disappears.

ENGLISH20