45
CCD-TR403_3-858-957-12.E/S
Additional Information Información adicional
(to be continued)
If you run into any problem using the camcorder, use the following table to troubleshoot the problem.
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.

Camcorder

Power

Symptom Cause and/or Corrective Actions
• The battery pack is not attached or not attached firmly.
mAttach the battery pack firmly by pushing the lower part of
the battery pack. (p. 8)
• The battery is dead.
mUse a charged battery pack. (p. 6)
• The AC power adaptor is not connected to a wall outlet.
mConnect the AC power adaptor to a wall outlet. (p. 22)
• While being operated in CAMERA mode, the camcorder has
been in the Standby mode for more than 5 minutes.
mTurn STANDBY down once and turn it up again. (p. 11)
• The battery is dead.
mUse a charged battery pack. (p. 6)
• The ambient temperature is too low. (p. 36)
• The battery pack has not been charged fully.
mCharge the battery pack again. (p. 6)
• The battery pack is completely dead, and cannot be recharged.
mUse another battery pack. (P. 21)

Operation

Symptom Cause and/or Corrective Actions
• The tape is stuck to the drum.
mEject the cassette. (p. 9)
• The tape has run out.
mRewind the tape or use a new one. (p. 19)
• The POWER switch is set to PLAYER.
mSet to CAMERA. (p. 10)
• The tab on cassette is out (red).
mUse a new cassette or slide the tab. (p. 9)
• The battery is dead.
m
Use a charged battery pack or the AC power adaptor. (p. 6, 22)
• Moisture condensation has occurred.
mRemove the cassette and leave the camcorder for at least an
hour. (p. 40)
• The POWER switch is set to CAMERA or OFF.
mSet it to PLAYER. (p. 19)
• The tape has run out.
mRewind the tape or use a new one. (p. 19)
The power is not on.
The power goes off.
The battery pack is quickly
discharged.
START/STOP does not operate.
The cassette cannot be
removed from the holder.
No function except for cassette
ejection works.

English

Trouble Check
The tape does not move when a
tape transport button is pressed.