Connecting your camcorder to a computer using the USB cable (For Windows users)

If you cannot install the USBdriver

Raccordement de votre caméscope

àvotre ordinateur à l’aide du câble USB (pour utilisateurs Windows)

S’il est impossible d’installer lepilote USB

The USB driver has been registered incorrectly as the computer was connected to your camcorder before installation of the USB driver was complete. Follow the procedure below to correctly install the USB driver.

Le pilote USB n’a pas été enregistré correctement, étant donné que l’ordinateur a été branché sur votre caméscope avant la fin de l’installation du pilote USB. Installez correctement le pilote USB en suivant la procédure ci-dessous.

Viewing pictures recorded on the tape

Step 1: Uninstall the incorrect USB driver

1Turn on the computer and allow Windows to load.

2Connect the AC Adaptor and set the POWER

switch to*1)/ *2).

3Connect the USB port on the computer to the

(USB) jack on your camcorder using the USB cable supplied.

4Open the computer’s “Device Manager.”

*1) DCR-PC103E only

*2) DCR-PC104E/PC105E only

Windows XP:

Select “Start” t “Control Panel” t “System” t “Hardware”, and click the “Device Manager” button.

If there is no “System” inside “Pick a category” after clicking “Control Panel,” click “Switch to classic view” instead.

Windows 2000:

Select “My Computer” t “Control Panel” t “System” t “Hardware” tab, and click the “Device Manager” button.

Windows 98SE/Windows Me:

Select “My Computer” t “Control Panel” t “System,” and click “Device Manager.”

Visionnage d’images enregistrées sur la cassette

Etape 1 : Désinstallez le pilote USB incorrect

1Mettez l’ordinateur sous tension et laissez Windows se charger.

2Raccordez l’adaptateur secteur AC et réglez le

commutateur POWER sur *1)/ *2).

3Raccordez le port USB de l’ordinateur à la

prise (USB) de votre caméscope à l’aide du câble USB fourni.

4Ouvrez le « Gestionnaire de périphériques » de l’ordinateur.

*1) DCR-PC103E seulement

*2) DCR-PC104E/PC105E seulement

Windows XP :

Sélectionnez « Démarrer » t « Panneau de configuration » t « Système » t « Matériel », puis cliquez sur le bouton « Gestionnaire de périphériques ».

Si vous ne trouvez pas « Système » dans

«Choisissez une catégorie » après avoir cliqué sur « Panneau de configuration », cliquez plutôt sur « Basculer vers l’affichage classique ».

Windows 2000 :

Sélectionnez « Poste de travail » t « Panneau de configuration » t « Système » t l’onglet

«Matériel », puis cliquez sur le bouton

«Gestionnaire de périphériques ».

Windows 98SE/Windows Me :

Sélectionnez « Poste de travail » t « Panneau de configuration » t « Système », puis cliquez sur « Gestionnaire de périphériques ».

ordinateur votre sur d’images Visionnage Computer your with Images Viewing

205