Sony DFS-700P, 702P SpecifiSpecificationsations, 1-102, General, Input signals, Output signals

1-102

Appendixes

SpecifiSpecificationsations

General

Signaling system DFS-700: NTSC DFS-700P: PAL

Power requirements

DFS-700: 100 V AC, 50/60 Hz

DFS-700P: 220/240 V AC, 50/60 Hz

Operating voltage DFS-700: 90 to 130 V AC, 47 to 63 Hz

DFS-700P: 180 to 260 V AC, 47 to 63 Hz

Power consumption

200W

Peak inrush current

(1)Power ON, current probe method: 24 A (240 V)

(2)Hot switching inrush current, measured in accordance with European standard EN55103-1:13 A (230 V)

Operating temperature

	0°C to 40°C (32°F to 104°F)
Dimensions	Control panel: 440 × 121 × 287 mm
	(w/h/d) (173/8 × 47/8 × 113/8
	inches)
	Processor: 440 × 133 × 520 mm

S/N	More than 50 dB (composite)
	More than 55 dB (component,
	S-Video)
System delay	1 frame
	Preread mode: Background bus
	only 4H

Input signals

VIDEO INPUT COMPONENT

BNC type (Y/R–Y/B–Y×)4 (with BKDF-701: × 8)

Y:1.0 Vp-p, 75 ohms R–Y/B–Y: 0.756 Vp-p, 75 ohms

RGBTo use some of the above COMPONENT connectors.

R/G/B: 0.756 Vp-p, 75 ohms, sync on green

COMPOSITE (with BKDF-702/702P) BNC type × 4

VIDEO: 1.0 Vp-p, 75 ohms, sync negative

S-VIDEO (with BKDF-702/702P) DIN × 4

Output signals

PGM OUT

SDIBNC type × 2

270 Mb/s, compliant with SMPTE-

259M

COMPONENT BNC type (Y/R–Y/B–Y×)2

	Y: 1.0 Vp-p, 75 ohms, sync
	negagive
	R–Y/B–Y: 0.756 Vp-p, 75 ohms
COMPOSITE	BNC type × 2
	Video: 1.0 Vp-p, 75 ohms,
	sync negative
S-VIDEO	DIN × 2
	Y: 1.0 Vp-p, 75 ohms, sync
	negative

C (BURST): 0.286 Vp-p, 75 ohms

CLEAN OUT BNC type × 1

SDI: 270 Mb/s, compliant with SMPTE-259M

BLACK BURST OUT

BNC type × 3 SYNC: 0.286 Vp-p BURST: 0.286 Vp-p

Supplied accessories

AC power cord (1)

25-pin control cable, 10 m (1) Button labels (1 set)

Tool for removing key tops (1) Operation manual (1)

Design and specifications subject to change without notice.

Appendixes

	(w/h/d) (173/8 × 51/4 × 201/2
	inches)
Mass	Control panel: Approx. 3 kg
	(6 lb 9 oz)
	Processor unit: Approx. 14 kg
	(30 lb 13 oz)

Signal processing

Sampling rate	Y: 13.5 MHz, R–Y/B–Y:
	6.75 MHz, KEY: 13.5 MHz
Quantizing	Y/R–Y/B–Y: 8 bits, KEY: 8 bits

Linearity (composite output) Differential gain

Less than 3.5% (composite input) Less than 2% (component, S-Video

input)

Differential phase

Less than 2.5º (composite input) Less than 1.0º (component,

S-Video input)

Frequency response

0 to 5 MHz + 0.5 dB/–1 dB

	Y: 1.0 Vp-p, 75 ohms, sync
	negative,
	C (BURST): 0.286 Vp-p, 75 ohms
REF. VIDEO	BNC type × 2, loop through
	SYNC: 0.286 Vp-p
	BURST: 0.286 Vp-p
SDI INPUT	BNC type × 4 (with BKDF-701:
	× 8)
	270 Mb/s, compliant with SMPTE-
	259M
DSK KEY IN	BNC type × 2, loop through
	1.0 Vp-p, 75 ohms, sync negative

Control signals

EDITOR	D-sub, 9-pin × 1 (RS-422A)
GPI T 1/2	BNC type × 2, TTL level, active
	low
PANEL	D-sub, 25-pin × 1
TALLYL	D-sub, 25-pin × 1, relay contact
	output × 8
TERMINAL	USB × 1

Recommended equipment and cables

Editing control unit

	PVE-500, BVE-900/910/2000,
	BVE-600
VTR	DSR-2000/2000P, DNW-75/75P
Audio mixer	SRP-V200R
Cables	RCC-5G/10G/30G 9-pin remote
	control cables

DFS-700/700P A-64Appendixes

Appendixes A-65