1-50
User Program Effects
Displaying parameter values
The numerical values of the parameters appear in the menu.
|
| Numerical parameter values |
| |
| Parameter | Function | Value range | Default |
| Movement along | 0 | ||
| Movement along | 0 | ||
| Magnification | 0 to 200 | 100 | |
| KfDur | Key frame duration | 1 to 100 | 50 |
| Rotation about the | 0 | ||
| Rotation about the | 0 | ||
| Rotation about the | 0 | ||
| Pers | Perspective | 0 to 400 | 200 |
| Angle | Direction of folding | 20 | |
| Offset | Degree of modification | 0 to 200 | 0 |
| Rotation about the | 0 | ||
| Radius | Radius | 0 to 100 | 0 |
| FORM | Type of modification | TURN, ROLL, SPHERE d) | TURN |
| a) 600 corresponds to the full width of the screen. |
| ||
| b) 300 corresponds to the full height of the screen. |
| ||
| c) 100 corresponds to 360 degrees. |
|
| |
| d) For SPHERE, the Angle and the Radius parameter do not function. |
| ||
Chapter 4 | Resetting the parameters to their initial values |
|
| |
Advanced | the PATTERN ADJ button. |
|
| |
Operations | • To reset all of the parameters, hold down the INITIAL button, and press | |||
• To reset all of the parameters on a particular page, hold down the | ||||
| The initial values of the parameters are for an unmodified image |
|
occupying the whole screen.
INITIAL button, and press the PAGE button.
• To reset a particular parameter only, press the corresponding function button while holding down the INITIAL button.
About the key frame duration
The KfDur value (key frame duration) for key frame n corresponds to the interval between key frame n and key frame n+1. Therefore, if the settings are as follows:
Key frame 1 ... not effective
Key frame 2 ... KfDur 100
Key frame 3 ... KfDur 50
Key frame 4 ... KfDur 50
The interval between key frames 1 and 2 is twice that between the other pairs of frames. For example, if the transition duration is set to 100 frames, the transition will proceed as follows:
Key frame 4 t 3 ... 25 frames
Key frame 3 t 2 ... 25 frames
Key frame 2 t 1 ... 50 frames
Setting the type of interpolation
When executing the effect, using the F1 button in the menu, you can set the type of interpolation between key frames as follows:
Lin: linear interpolation
Spln: spline interpolation
If you select
Chapter 4 Advanced Operations
Chapter 4 Advanced Operations |