Sony DHC-MD373 manual Marking track numbers, 4,5, Press Function repeatedly until Tuner appears

Marking track numbers

You can mark track numbers:

•Automatically during recording

`/1

7

Z HS x

Track numbers are automatically marked as on the original source during recording from this system’s CD player or components connected to the DIGITAL OPTICAL IN jack. Use the Level Synchro Recording function to automatically mark track numbers during recording from this system’s tuner or components connected to the LINE IN jack or the TAPE IN jacks. However, you cannot mark track numbers automatically if the sound source to be recorded is noisy (e.g., tapes or radio programmes) or during timer-recording.

•At any point during recording

You can mark track numbers during recording any sources.

•After recording

Use the Divide Function (see page 41).

Marking track numbers automatically during

recording — Level-Synchro Recording

The Level Synchro Recording function is factory set to on, so the track numbers are automatically marked. If “LEVEL-SYNC” does not appear during recording, turn on the Level Synchro Recording as follows. Track numbers are automatically marked when the input signal is continuously below a certain level for more than two seconds and then exceeds that level.

Note

You can not mark track numbers automatically if the sound source to be recorded is noisy (e.g,. tapes or radio programmes).

Z HS x

z

. m M >

2 1

`/1

3,6 3,4,5

mM

4,5 . > 4,5

H

1 Press FUNCTION repeatedly until “TUNER” appears.

To record from other components connected to this system, select “TAPE” or “LINE IN”.

2 Press z REC to stand by for recording.

3 Press MENU/NO on the remote.

“Setup ?” appears, then press ENTER/YES on the remote.

4 Press . or > on the remote repeatedly until “T.Mark Off” appears, then press ENTER/YES.

5 Press . or > repeatedly until “T.Mark LSync” appears, then press ENTER/YES.

“LEVEL-SYNC” lights up.

30