1 Remove the insulation sheet from the remote commander.
With the insulation sheet removed from the lithium battery, the remote commander is ready for use.
Replacing batteries
When the printer does not respond to the remote commander, the battery may run out.
1 Push in the tab (1) and then slide out the battery compartment lid (2).
2 Remove the used battery and then insert a new lithium battery (CR2025) into the compartment with the + and – properly aligned.
Friction seal
2 Point the remote commander to the remote sensor on the printer and then press a button to operate the printer.
You can use the buttons on the remote
commander in the same way as thoseLithium battery identical buttons on the printer.
Remote sensor
Note
Pressing CANCEL button on a remote commander for more than one second does not function.
3 Slide the battery compartment lid back into the commander until it clicks into place.
WARNING:
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
Notes
•The
•Point the remote sensor away from strong light sources such as direct sunlight or overhead lighting. Otherwise, the remote commander may not function properly.