Correcting a failed photo automatically (AUTO TOUCH-UP)

1 Select the image that you want to adjust and then press AUTO TOUCH-UP.

Adjustment of the selected image starts. The adjustment results will be displayed on the screen. When a human face is detected, the face is displayed with a frame as the adjustments proceed.

To check the adjustment result more clearly:

Press to enlarge the image. (The image will not be enlarged when printed.)

To display the original image (before adjustments) again

Press AUTO TOUCH-UP. To display the adjusted image, press AUTO TOUCH-UP again.

If you have set a print quantity for multiple images

All the images with print quantity settings are adjusted. To display other images, press g/G.

To change the print quantity

Press ENTER to display the print quantity indication. Then press f/F to set the print quantity and then press ENTER.

2 Press PRINT.

Printing of the selected image(s) starts.

Tip

Adjustment takes effect only on the image being printed. The original image will not be adjusted.

Notes

•After the AUTO TOUCH-UP adjustment, you cannot make a trimming print of an image that has been enlarged by pressing .

•Depending on the image, a face may not be automatically detected. If the brightness of the face is not adjusted properly, select “Adjust” from the Edit menu to adjust the brightness manually (page 22).

•Depending on the image, the out-of-focus phenomenon may not be corrected. In this case, use the “Sharpness” function from Adjust in the Edit menu to adjust the sharpness manually (page 22).

•Out-of-focus reduction does not take effect on blur caused by shaking of the camera.

•Depending on the image, the red-eye phenomenon may not be corrected. In this case, perform red-eye correction to make red-eye adjustments manually (page 24).

The automatic red-eye correction function of this printer uses the technology of FotoNation Inc. in the U.S.A.

The “Skin Smoothing” correction function of the printer uses the technology of Ichikawa Soft Laboratory.

20 GB