Correcting the red-eye phenomenon

When pressing AUTO TOUCH-UP cannot reduce the red-eye phenomenon of a subject shot by flash, you can adjust the image manually.

Note

If you perform additional editing, such as enlarging, reducing the image size, rotating or moving an image, after the red-eye correction, the red-eye correction may not take effect. Perform the red-eye correction after these editorial operations.

1 From the Edit menu (page 18), press g/G to select (Red-eye Correction) and then press ENTER.

The adjustment frame appears on the image, which indicates the range for red- eye correction.

Adjustment frame

2 Adjust the position and size of the adjustment frame.

Make the red-eye correction for the right and left eyes separately.

xTo move the adjustment frame

1Press g/G to select (Move) and

press ENTER.

2Move the frame with g/G/f/F. The frame moves in the selected direction.

3Press ENTER.

The frame is fixed in the current position.

xTo change the size of the adjustment frame

Press g/G to select (Enlarge) or (Reduce) and press ENTER.

Each time you press ENTER, the frame becomes larger or smaller.

You can also enlarge or reduce the size by pressing the (zoom in) or (zoom out) buttons on the printer.

Tip

Make the size of the adjustment frame 2 to 7 times as large as the eye size.

3 Press g/G to select and press

ENTER.

The range of red-eye correction is enlarged.

4 Press ENTER.

The adjustment takes effect. The Red-eye correction menu is displayed.

To make a red-eye correction for other eyes, repeat steps 2 to 4.

5 Press g/G to select and press

ENTER.

The Edit menu is displayed again.

6 Press PRINT.

To reset the adjustment

Press CANCEL in step 5 instead of ENTER.

24 GB