Sony 85P, DSR-85 R–Y, and, R–Y, and, B–Y:, B–Y:, 3TIME CODE IN connector (BNC type), TIME CODE OUT connector (BNC type), 1Analog video signal input/output section

1Analog video signal input/output section

ANALOG I/O

5VIDEO IN connectors and 75 Ω termination switch

1REF. VIDEO IN connectors and 75 Ω termination switch

2REF. VIDEO OUT connector

3TIME CODE IN connector

4TIME CODE OUT connector

REF.VIDEO

IN

75Ω

ON

OFF

OUT

TIME CODE

IN

OUT

VIDEO IN	VIDEO OUT
	1
	75Ω
	ON
	2
	(SUPER)
	OFF

COMPONENT VIDEO

INOUT

Y

R-Y

B-Y

6VIDEO OUT 1 and 2 (SUPER) connectors

7COMPONENT VIDEO IN connectors

8COMPONENT VIDEO OUT connectors

9S VIDEO IN connector

Overview 1 Chapter

MONITOR		S VIDEO
AUDIO	IN	OUT

0S VIDEO OUT connector

1REF. (reference) VIDEO IN (input) connectors (BNC type) and 75 Ω termination switch

Input a reference video signal to one of these connectors. The two connectors can be used for a

loop-through connection. When making a loop- through connection, set the 75 Ω termination switch to OFF and when not, set the switch to ON.

2REF. (reference) VIDEO OUT (output) connector (BNC type)

Outputs a reference video signal.

3TIME CODE IN connector (BNC type)

Input SMPTE time code (DSR-85) or EBU time code (DSR-85P) externally generated.

4TIME CODE OUT connector (BNC type) When the unit is in normal-speed playback mode, this connector outputs the time code read from the tape as an analog (LTC) signal. When the unit is in any other mode, the connector outputs no signal.

Note

The TIME CODE IN connector and TIME CODE OUT connector can only be used when an optional DSBK-130/130P Time Code Input/Output Board is installed in this unit.

5VIDEO IN connectors (BNC type) and 75 Ω termination switch

Input a composite video signal to one of these connectors. The two connectors can be used for a

loop-through connection. When making a loop- through connection, set the 75 Ω termination switch to OFF and when not, set the switch to ON.

6VIDEO OUT 1 and 2 (SUPER) connectors (BNC type)

Output a composite video signal. When “CHARA. DISPLAY” under the DISPLAY CONTROL menu item has been set to “ON” (factory default setting), a character signal is superimposed on the video signal that is output from the VIDEO OUT 2 (SUPER) connector.

7COMPONENT VIDEO IN connectors (BNC type)

Input a component (Y/R–Y/B–Y) signal.

Y:Luminance signal

R–Y and B–Y:Color difference signals

8COMPONENT VIDEO OUT connectors (BNC type)

Output a component (Y/R–Y/B–Y) signal.

Y:Luminance signal

R–Y and B–Y:Color difference signals

Chapter 1 Overview 15