SEND ADDRESS BOOK

 

 

< 01: AAAAAAAA

>

Transfer destination host a)

HOST: HOST2

 

 

 

 

SEND : SET KEY

TO MENU : MENU KEY

a) "--------" is displayed when no destination host is selected.

2 If the destination host is correct, press the SET button.

To select the destination host, execute steps 2 to 4 of “Sending Clip Data” (page 52) and press the SET button.

Preparations for communications start.

When the preparations finish, the message “Issuing transfer request. Will begin transfer after the end of transfer standby.” appears.

Up to 29 transfer requests can be placed on standby. When the 30th request is issued, the message “Request queue full. Cannot send clip.” appears and the transfer is rejected.

To cancel the transfer

In step 2, press the MENU button instead of the SET button.

Operations Network 5 Chapter

Receiving Data

You can specify the names of clips recorded by other recorders on the network and receive those clips over the network. After receiving the data, you can choose whether to save or delete it. Up to 100 data items can be received. The following procedure allows you to receive clip data that has been recorded on other recorders.

Note

Data cannot be received when there is 10 minutes or less of free disk capacity. If free disk capacity has fallen to 10 minutes or less, you should make more capacity available by deleting recorded clips before carrying out this operation.

1 Select the RECEIVE item on the Network menu and press the k (OUT) button.

NETWORK MENU

 

Receive

SEND

 

 

CLIP

 

 

Time counter display

 

 

 

CLIPLIST

A/V/TC/CM

 

 

ADDRESS BOOK

 

 

 

 

 

 

RECEIVE

 

 

 

ADDRESS BOOK

 

 

 

NEW CONTENTS LIST

 

 

STATUS

 

 

 

 

 

 

 

Monitor screen

The RECEIVE CLIP screen appears, showing the currently selected source host and the name of the target clip.

RECEIVE CLIP

 

 

< 01: AAAAAAAA

>

Transfer source host a)

HOST: HOST2

 

 

 

 

CLIP: 0001

 

 

 

Name of clip to receive b)

 

 

 

RECEIVE : SET KEY

TO MENU : MENU KEY

a)“--------” is displayed when no source host is selected.

b)“----” is displayed when no clip is selected.

2 If the source host and clip are correct, proceed to step 5.

To select the destination host, execute steps 2 to 4 of “Sending Clip Data” (page 52).

54 Receiving Data