3 Turn the eyepiece locking ring clockwise until its “LOCK” arrow points at the red mark on the viewfinder barrel.
Note
When the eyecup is worn out, replace it with a new one (service part number
Camcorder the Up Setting 7 Chapter
7-3 Mounting the Lens
To mount the lens, proceed as follows:
For information about using the lens, refer to the lens manual.
Lens mount
1 3 securing rubber
5 4 2
Mounting the lens
1 Push the lens locking lever upward and remove the lens mount cap from the lens mount.
2 Align the center slot in the lens mount with the center
pin on the lens and insert the lens into the mount.
3 Holding the lens in place, push the lens locking lever downward to mount the lens.
Note
If the lens is not firmly locked, it may come off while the camcorder is being used. This could cause a serious accident. Make sure the lens is firmly locked. It is recommended that the lens mount securing rubber (supplied) be put on the
4 Connect the lens cable to the LENS connector.
Note
Connecting a cable to the LENS connector while in powered status may cause a malfunction or damage the unit. Turn off the power before you make a connection with the LENS connector.
5 Secure the lens cable with the cable clamps.
114 Mounting the Lens