Maintenance 8 Chapter
Operation/error messages
An operation or error message is displayed in the operation/error message display area (see page 78) in the viewfinder.
Operation/error | Meaning | |
message |
|
|
AUTO INTERVAL | Indicates the camera is in the Auto | |
**M**S | Interval Rec mode. **M**S indicates | |
| the shooting interval. | |
|
| |
MANU INTERVAL | Indicates the camera is in the single | |
*FRAME | shot mode of the Manual Interval Rec | |
| mode. *FRAME indicates the number | |
| of frames. | |
|
| |
INTERVAL **S(M/ | Indicates the camera is in the | |
H)*FRAME | consecutive mode of the Manual | |
| Interval Rec mode. **S(M/H) indicates | |
| the trigger interval and *FRAME | |
| indicates the number of frames. | |
|
| |
LOW LIGHT | Appears, if set to ON on the menu, to | |
| indicate the subject illumination is | |
| inadequate. | |
|
| |
TAPE REC INH. | Appears when recording on a write- | |
| protected cassette. | |
|
| |
Retake Search | Appears when the camcorder fails to | |
Failed | position the tape at recording starting | |
| point when recording using the RE- | |
| TAKE function.1) | |
Humid Disturbed | Appears when there are portions | |
INT REC | where recording has failed due to | |
| condensation while shooting pictures | |
| at intervals (using the interval rec | |
| function). | |
|
| |
INVALID | Appears when: | |
OPERATION | • there is only one recorded cut when | |
|
| recording using the |
|
| function. |
| • | the recorded cuts are less than 3 |
|
| sec. when recording using the RE- |
|
| TAKE function. |
| • | the |
|
| for some reason, e.g. as Picture |
|
| Cache was on. |
| • | when you execute the |
|
| operation before the recording |
|
| pause operation has completed. |
|
| |
Appears when the backup battery for | ||
BATTERY EMPTY | the internal clock has been used up.2) |
1)In this case, position the tape at the point where you want to start the recording manually.
2)To replace the backup battery, contact your nearest Sony dealer.
Notes on CCD image sensors
Vertical smear
Smear tends to be produced when an extremely bright object is being shot; it is more likely to occur with a faster electronic shutter speed.
Vertical tails show on the image.
Bright object (mercury lamp, the sun, reflections, etc.)
Monitor screen
Vertical smear
Aliasing
When patterns of stripes or lines are shot, they may appear jagged.
130 Operation Warnings