Screws removed in step 1

CAC-12

3 Open the CAC-12 and remove the microphone adaptor.

Open the CAC-12.

Microphone adaptor 1)

Loosen the screw.

1)Attach the microphone adaptor when using a small- diameter external microphone.

4 Place an ECM-672 electret condenser microphone in the CAC-12.

Close the CAC-12.

Tighten the screw.

ECM-672 or similar

f

microphone

 

Note

When you detach the CAC-12 Microphone Holder once you have attached to the camcorder, be careful not to lose the two screws fixing the CAC-12. After detaching the CAC-12, be sure to put the two screws back into their original places (see the figure illustrating the step 1 operation).

7-5-3 Attaching a UHF Portable

Tuner (for a UHF Wireless

Microphone System)

To use a Sony UHF wireless microphone system, fit one of the following UHF portable tuners.

•WRR-855A/855B UHF Synthesized Tuner Unit

•WRR-860/862 UHF Portable Tuner.

For each of these UHF portable tuners, use the following attachment procedure.

For details, refer to the UHF portable turner manual.

Fitting the WRR-855A/855B

You can use the WRR-855A/855B UHF Synthesized Tuner Unit simply by inserting it into the slot in the camcorder, and fastening the fixing screws.

1 Undo the four fixing screws holding the cover of the slot, and remove the cover.

2 Insert the WRR-855A/855B, and fasten the four fixing screws.

Camcorder the Up Setting 7 Chapter

5 Connect the microphone cable to the AUDIO IN CH1 or AUDIO IN CH2 connector.

Set the LINE/MIC/+48 V ON switch to +48 V ON if you use an external power supply type microphone. Otherwise, set the switch to MIC.

Audio Input System 117