Playback and Recording 3 Chapter
3 Push the MENU knob.
The ? mark on the left of setting returns to a z mark, and the z mark on the left of “TRIGGER INTERVAL” returns to an b mark.
4 Turn the MENU knob to move the b mark to PRE-
LIGHTING.
U03 FUNCTION1 |
|
| ||
ASSIGN | SW | <1> | : | ATW |
ASSIGN | SW | <2> | : | OFF |
TURBO | SW |
| : | TURBO |
DF/NDF |
|
| : | DF |
END SEARCH |
| : | OFF | |
CACHE/INTVAL | REC: | M.INT | ||
NUMBER | OF | FRAME : | 1 | |
TRIGGER INTERVAL: | 1SEC | |||
: | OFF | |||
|
|
|
|
|
5 Push the MENU knob.
The b mark on the left of
6 Turn the MENU knob clockwise or counterclockwise until the desired time interval at which to turn on the light before recording starts appears.
If you turn the MENU knob clockwise or counterclockwise, the
y10SEC.
Notes
•To turn on the light automatically before recording starts by setting the
The light automatically turns on and off in Continuous Trigger mode of Manual Interval Rec. However, if the duration the light should be off is less than 5 seconds, the light is on continuously.
•When the LIGHT switch is set to MANUAL and the switch of the light is set to ON, the light is always on.
7 Push the MENU knob.
The ? mark on the left of setting returns to a z mark and the z mark on the left of
8 To end the menu operation, set the MENU ON/OFF switch to OFF or close the cover of the menu operating section.
The menu disappears from the viewfinder screen and the message INTERVAL *SEC *FRAME, indicating Continuous Trigger mode of Manual Interval Rec, appears along the bottom of the viewfinder.
*SEC indicates the trigger interval preset and *FRAME indicates the number of frames preset. The display indicating the current status of the camcorder appears along the top and bottom of the viewfinder.
Note
The settings for Continuous Trigger mode of Manual Interval Rec are maintained until changed. However, if you switch the camcorder power off, all Manual Interval Rec mode settings are cleared except for the NUMBER OF FRAME, TRIGGER INTERVAL, and
Recording in Continuous Trigger mode of Manual Interval Rec
Follow the procedure below to shoot pictures in Continuous Trigger mode of Manual Interval Rec.
Note
When you use cassettes on which nothing is recorded, such as brand new cassettes, be sure to record color bars for more than 2 seconds at the beginning of a cassette.
1 After performing the basic procedures for shooting and recording following the instructions in
2 Push the VTR START button on the camcorder or the VTR button on the lens.
The camcorder starts recording in Continuous Trigger mode of Manual Interval Rec, and the flashing cycle of the TALLY indicator (green) changes from 1 flash/ second to 4 flashes/second, and the message INTERVAL *SEC *FRAME flashes on the viewfinder screen.
When you use the
To stop recording in Continuous Trigger mode of Manual Interval Rec
You can stop recording in Continuous Trigger mode of Manual Interval Rec using the following two methods. However, the tape may continue to run to record the picture data stored in the memory at the instant the tape stopped.
50 Recording