fMENU SEL (selection) /ENTER dial

Used to select or set the items on the subdisplay or the menu items on the viewfinder (monitor) screen.

Rear panel

Overview 1 Chapter

aSafety release tab

bAccessory clamp lever

cLock release knob2 dAccessory mount lever

3

eRecorder/interface box receptacles

fRUN indicator and ON/OFF switch

OFF ON

gGENLOCK IN connector

hTEST OUT connector

iMONITOR OUT HD SDI connectors 1/2

REMOTEjREMOTE connector

DC IN connector (see page 11)

kWrench box

aSafety release tab b Accessory clamp lever c Lock release knob d Accessory mount lever

For mounting/unmounting an SRW-1 HD Portable Digital Recorder or the interface box to/from the rear of the camera head.

The mounting/unmounting mechanism is the same as that on the top (page 13).

For details, see “Chapter 2 Installation and Preparations”.

eRecorder/interface box receptacles

Signals and power are sent/received to/from an SRW-1 HD Portable Digital Recorder or the supplied interface box (page 15) mounted on the rear.

The same receptacles are provided on the top to send/ receive signals and power to/from the recorder or the interface box mounted on the top.

When using a rechargeable battery

Use the receptacles on the rear panel. By attaching the BKP-L551 to the rear of the interface box, the camera can be operated on a battery. Note, however, that power will be fed only to the camera head and viewfinder. Provide another power source for the recorder.

fRUN indicator and ON/OFF switch

When the switch is set to ON, the indicator will be lit while the recorder mounted on the camera is in Recording mode.

gGENLOCK IN (external sync signal input) connector (BNC type)Used for input of an external gen-lock signal (HD 3-level sync).hTEST OUT connector (BNC type)An analog test signal is fed from the connector.

The type of output signal can be set using a menu on the viewfinder or monitor screen.

iMONITOR OUT HD SDI connectors 1/2 (BNC type)An HD SDI signal for monitoring is fed from the connectors.

The type of output signal can be set using a menu on the viewfinder or monitor screen.

The same signal is output from connector 1 and 2.jREMOTE connector (8-pin)

Connect an external control device, such as the RM-B150/ B750 Remote Control Unit.

kWrench box

A 3-mm wrench for attaching/detaching the handle and a 2.5-mm wrench for attaching/detaching the viewfinder shoe are accommodated.

14

Locations and Functions of Parts