Installation and Preparations

2-1 Mounting the Interface Box

The supplied interface box can be attached to the top or rear of the camera head.

Connection between the camera head and the interface box is achieved by mounting, eliminating additional cable connections.

•The same attaching/detaching system is used both on the top and the rear.

•The following instructions use the illustrations of attaching to the rear as examples.

•Although the illustrations show the statuses where the L handle has been detached, the interface box can be mounted/unmounted with the L handle attached.

To attach

1 Place the camera head on a stable, flat surface.

2 Rotate the accessory clamp lever upward (toward the lens when attaching to the top).

Accessory clamp lever

Chapter 2

3

Release the lock by sliding the lock-release knob in the

Chapter

 

 

direction of the arrow (1 in the figure below) then pull

2

 

up the accessory mount lever (pull it toward the lens

 

PreparationsandInstallation

 

when mounting on the top) (2 in the figure below).

 

 

Lock-release knob

Accessory mount lever

4 Aligning the matching line on the interface box with that on the camera head, fit the interface box into the camera head then push down on the box (slide it in the opposite direction of the lens when attaching to the top) so that the connectors engage.

Matching line on

Matching line on the interface box the camera head

Mounting the Interface Box

17