1-3-2 Assistant Panel (Supplied)

The most parts are common to those on the right panel of the camera head. Connecting the panel to the CONTROL PANEL connector (page 10) of the camera head permits the camera and recorder to be operated at hand.

aCAMERA connector LOCK switch

VF MENU/DISPLAY button

Assignable buttons 1, 2, 3

CANCEL/STATUS button

bAUX connector

LOCK

VF MENU/DISPLAY CANCEL/STATUS

MENU SEL/

ENTER

RUN

4

AUTO

BLK BAL

PAGE SET

MENU SEL/ENTER dial

Subdisplay

SET button

PAGE button

4/AUTO BLK BAL switch

RUN button and indicator

aCAMERA connector

Using the supplied assistant panel cable, connect to the CONTROL PANEL connector of the camera head.

bAUX (auxiliary) connectorConnect to an external device as required.

The other parts function the same as those on the right side panel of the camera head.

Note

If the assistant panel cable is disconnected/connected while you are operating the subdisplay or a menu on the viewfinder/monitor screen, the cursor/pointer on the subdisplay or on the menu page may inadvertently be moved. If a ? symbol is shown on the display, first register the setting, then disconnect/connect the cable.

1-3-3 Interface Box (Supplied)

Being attached to the top or the rear of the camera head, it transfers signals and power to/from the camera head.

aAUDIO IN CH-1/CH-2 connectors

bAudio input selection switches

LINE

MIC

CH-1

+48V ON

 

 

IN

LINE

+48V ONAUDIO

MIC

CH-2

 

eCamera connector 1

A

B

HD-SDI

 

fCamera connector 2

dDC IN connector (bottom)

cHD-SDI A/B connectors

aAUDIO IN CH-1/CH-2 connectors (XLR 3-pin, female)

Connect audio signals. Each connector is equipped with an input selection switch.

bAudio input selection switches

Set to the appropriate position according to the equipment connected to the corresponding AUDIO IN connector. LINE: When a line-level (+4 dBu) signal source is

connectedMIC: When an external microphone is connected (No power is supplied.)+48 V ON: To supply power of +48 V to the connected microphonecHD-SDI A/B connectorsFor Dual Link outputs of an HD-SDI signal.dDC IN connector (XLR 4-pin)

Connecting the BKP-L551 Battery Adaptor or a specified power cable, supply power to the interface box. The power is also fed to the camera head, viewfinder, and lens.

Note

Power is not fed to an SRW-1 recorder.

Overview 1 Chapter

Locations and Functions of Parts

15