Sony HCD-C5 service manual Spindle Motor Assy M904, Jack BOARD, HP BOARD, Rear Cover

HCD-C5

3-12. SPINDLE MOTOR ASSY (M904)

3 open to direction of the arrow A 2 clip arm spring

4 two screws (+P 1.7 x 2.2)

A

1clip arm spring (L)

8spindle motor assy (M904)

5 turn table

6 washer

7spindle motor

3-13. JACK BOARD, HP BOARD, REAR COVER	4 screw	8 two screws
	(+PTPWH 3 x 8)	(+B 4 x 16)
		7 HP board
	6 connector
1 screw	(CN110)
(+BVTT 3 x 5)

Note for re-installation-1

When installing the rear cover,

be careful that the three harnesses coming from

“2 Connector (CN107)”,

“5 Connector (CN109)”,

“6 Connector (CN110)”,

and the harness coming from the DC fan (M901) must not contact the heat sink (IC902) and the diode (D981) and the heat sink (IC904).

5 connector (CN109)

2 four screws
(+BV 3 x 12)	9 two nuts
	(N4)

3three screws (+BV 3 x 8)

POWER board

heat sink (IC902)

diode (D981)

D.C.fan

(M901)

q; rear cover

3 JACK board

2connector

(CN107)	1 two screws
	(+BV 3 x 8)

Note for re-installation-2

When installing the rear cover, be careful that the three harnesses coming from

“2 Connector (CN107)”,

“5 Connector (CN109)”,

“6 Connector (CN110)”,

and the harness coming from the D.C. fan (M901) must not be pinched by the rear cover, the UCOM board, power transformer (T900) and tuner pack.

18