You cannot turn the LCD backlight off

Another VCR malfunctions when you

use the supplied Remote Commander.

•Select a con'unandcr mode ()tiler than VTR 2 for your VCR.

•Cover the sensor of your VCR with black paper.

The power abruptly turns off.

•When approximately 5 minutes ha_e elapsed while you do not operate your camcorder, the camcorder is automatically turned off (A.SHUT OFF). Change the setting of [A.SHUT OFF] (p. 61), or turn on the power again (p. 16), or use the AC Adaptor.

•Charge the battery pack (p. 13).

The _/CHG (charge) lamp does not light while the battery pack is being charged.

•Slide tile POWER sx_itch to OFF (CHG) (p. 13).

•Attach the hattery pack to the camcorder correctly (p. 13).

•Connect Ihe power cord (mains lead) to the wall outlet (wall socket) properly.

•The battery charge is completed lp. 13).

The _/CHG (charge) lamp flashes

while the battery pack is being

charged.

•Attach the battery Dack to the camcorder correctly (p. 13). If the problem persists, disconnect the AC Adaptor from the wall outlet (wall socket) and contact your Sony dealer. The battery pack may be damaged.

The remaining battery time indicator does not indicate the correct time.

•Amhient temperature is too high or to() low, or the hattery pack has not been ch irge(l enough. This is not a malfunction.

•Fully charge the hattery ag lin. If the problem persists, filebattery may be worn- out. Replace it with a new one (p. 13, 93).

•The indicated time may not be correct in

certain circtlnlstances.

For examp]e, when

you open or close the LCD panel it takes about 1 minute to display the correct remaining battery time.

The battery pack discharges too quickly.

•Ambient temperature is too high or low, or the battely, pack has not been charged enough. This is not a malffmction.

•Fully charge the hattery again. If the problem persists, the h ittery may be worn- out. Replace it with a new one (p. 13, 93).