Parts of Function and Location 2 Chapter

2-1 Control Panels2-1-1 Upper Control Panel

1 POWER switch

2 REMOTE buttons and RS-232C indicator

3 EJECT button

4 Format indicators

Cassette compartment

 

BETACAM/SP BETACAM SX MPEG IMX Digital BETACAM HDCAM

 

POWER

REMOTE

EJECT

1(9P)

2(50P) RS-232C

 

 

 

Z

PHONES

 

 

5PHONES jack and control

1 POWER switch

4 Format indicators

Pressing the ‘ ) ’ side of the switch powers the unit on. When the unit is powered on, the audio setting display section (see page 2-4)and the time data/menu display section (see page 2-6)light.

2REMOTE buttons and RS-232C indicator Press the 1 (9P) button or 2 (50P) button to select the device controlling this unit.

1(9P): This unit is controlled by the device connected to the REMOTE 1-IN(9P) or REMOTE

1-OUT(9P) connector. The button lights when pressed.

2(50P): This unit is controlled by the device connected to the REMOTE 2 PARALLEL I/O(50P) connector. The button lights when pressed.

RS-232C indicator: This indicator lights when this unit is controlled through the RS-232C connector.

3EJECT button

To eject the cassette, press this button. While the cassette is being ejected, this button lights.

When using the lower control panel as remote control panel, press the DELETE button and STOP button at the same time to eject the cassette.

Note

Ejecting with the EJECT button is a local operation. It is not possible to eject a cassette in another unit by remote control.

The indicator (BETACAM/SP, BETACAM SX, MPEG IMX, Digital BETACAM, or HDCAM) corresponding to the current recording or playback format lights. The BETACAM/SP lights when the format is Betacam or Betacam SP.

5PHONES jack and control

Connect stereo headphones with an impedance of

8 ohms, to monitor the sound during playback and editing.

The control knob adjusts the volume.

It is possible to set an internal board switch so that the output volume from the MONITOR OUTPUT L and R connectors is controlled simultaneously.

For details, refer to the Installation Manual.

2-2

Chapter 2 Location and Function of Parts