7LEARN button
After setting a speed variation start point (STUNT IN point) and a speed variation end point (STUNT OUT point), pressing this button makes the tape start running. You can then use the search dial to vary the tape speed, which is automatically stored in memory. After thus storing the tape speed variation in memory, pressing this button starts an automatic playback between the speed variation start and end points at the stored speed.
qa Shot mark section
1LIST button
2REC/ERASE indicator
LIST GOOD SHOT MARK |
|
REC/ | 3 MARK button |
ERASE |
1LIST button
Use this button to read in and list shot marks.
2REC/ERASE indicator
This lights in the state in which writing, amending, and deleting of shot marks is enabled and flashes while a shot mark is actually being written, amended or deleted.
3MARK button
Hold this button down for 2 seconds or more, to enable writing, amending, and deleting of shot marks.
Parts of Function and Location 2 Chapter
To access the switch panel, open the lower control panel.
On how to open the lower control panel, see the figure on page
1 Memory card slot
2 Memory card ejection button
3 CONTROL PANEL connector
CONTROL PANEL
KEY INHI | PANEL SEL |
ON OFF REAR FRONT
4 PANEL SELECT switch
5 KEY INHI switch
6Memory stick slot
Chapter 2 Location and Function of Parts |