5Power supply section

1 AC IN connector

2 Ground terminal

1AC IN connector

Use the optional power cord to connect this to an AC outlet.

2Ground terminal Connect this to ground.

6External device connectors

REMOTE 2 PARALLEL I/O(50P)

1 REMOTE 2 PARALLEL I/O(50P) connector

REMOTE 1-IN(9P) CONTROL PANEL

2 CONTROL PANEL

REMOTE 1-OUT(9P)

connector

VIDEO CONTROL (15P)

 

3 VIDEO CONTROL(15P)

RS232C

connector

VIDEO CONTROL (9P)

4 VIDEO CONTROL(9P) connector

5 REMOTE 1-IN(9P) connector

6 REMOTE 1-OUT(9P) connector

7 RS-232C connector

1REMOTE 2 PARALLEL I/O(50P) connector (D-sub 50-pin)

Connect remote control signals from an external device.

For details, refer to the Installation Manual.

2CONTROL PANEL connector (round type, 10- pin)

In addition to the lower control panel, a similar control panel can be connected to this unit. To connect such a second control panel, use this connector. When two control panels are connected, use the PANEL SELECT switch on the switch panel (see page 2-11)to specify which control panel will control this unit.

3VIDEO CONTROL(15P) connector (D-sub 15- pin)

For remote control of the internal digital video processor, connect an optional BVR-50/50P Video Remote Control Unit.

Always power off this unit before connecting the remote control unit.

4VIDEO CONTROL(9P) connector (D-sub 9-pin) For remote control of the internal digital video processor, connect an optional HKDV-900 Video Remote Control Unit.

Always power off this unit before connecting the remote control unit.

5REMOTE 1-IN(9P) connector (D-sub 9-pin) When using this unit together with another HDCAM VTR, and a BVE-seriesBVE-700/900/910/2000/9000/ 9000P/9100/9100P or other editor, connect the optional 9-pin remote control cable from the other unit to this connector.

Depending on the setting of setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-OUT(9P) connector.

6REMOTE 1-OUT(9P) connector (D-sub 9-pin) This provides the loop-through output for remote control signals from the REMOTE 1-IN(9P) connector.

Depending on the setting of setup menu item 211, you can use this connector alone, or in a loop-through configuration with the REMOTE 1-IN(9P) connector.

7RS-232C connector (D-sub 9-pin)

Use this for monitoring and diagnosis of the state of this unit from an external computer, using the ISR (Interactive Status Reporting) function.

Parts of Function and Location 2 Chapter

Chapter 2 Location and Function of Parts

2-15