Parts of Function and Location 2 Chapter

2-1 Control Panels

q; Editing control section

1DMC EDIT button

2MEMORY indicator

3DELETE button

4TRIM buttons

 

5 DMC playback control

 

 

point setting buttons

 

TRIM

 

 

IN

PLAY OUT

DMC EDIT

DELETE

ENTRY

 

 

MEMORY

 

LEARN

CUE/PLAY

 

 

IN

STUNT OUT

6CUE/PLAY button

7LEARN button

1DMC EDIT button

Use this button to memorize the playback speed varied between –1 and +2 times normal speed, and carry out automatic playback or automatic editing using the memorized playback speed.

2MEMORY indicator

When memorizing the playback speed using the DMC EDIT button, this indicator flashes as the playback speed is captured to memory, and lights continuously once the speed is captured.

3DELETE button

This deletes an existing edit point.

Hold down this button and press the STUNT IN, STUNT OUT, PLAY IN, or PLAY OUT button which is lit, indicating an existing edit point, to delete the corresponding edit point. The button either goes off or flashes. When the button flashes, it is necessary to set the deleted edit point again.

To cancel the DMC mode, hold down the DMC EDIT button and press the DELETE button.

4TRIM buttons

Use these buttons to trim an edit point to single-frame precision.

Hold down the STUNT IN, STUNT OUT, PLAY IN, or PLAY OUT button, and press one of these buttons. The ‘+’ button advances the corresponding edit point by one frame, and the ‘–’ button sets it back by one frame.

Pressing one of these buttons while holding down the PLAY button adjusts the tape speed by +8% or –8% correspondingly. (Capstan override function)

5DMC playback control point setting buttons PLAY IN button and PLAY OUT button

To set an on-air start or end point, hold down the PLAY IN button or PLAY OUT button, and press the ENTRY button.

After you have made the setting, pressing the PLAY IN button or PLAY OUT button displays the on-air start or end point set in time data display area 2.

STUNT IN button and STUNT OUT button

To set a speed variation start or end point, hold down the STUNT IN button or STUNT OUT button, and press the ENTRY button.

After you have made the setting, pressing the STUNT IN button or STUNT OUT button displays the speed variation start or end point set in time data display area 2.

ENTRY button

Use this for setting DMC playback control points and so on.

•To set a speed variation start or end point: Hold down the STUNT IN button or STUNT OUT button, and press this button.

•To set an on-air start or end point: Hold down the PLAY IN button or PLAY OUT button, and press this button.

6CUE/PLAY (cue up/playback) button

After setting an on-air start point (PLAY IN point) or an on-air end point (PLAY OUT point), pressing this button cues up the tape to the on-air start point. The button then starts flashing to indicate that the unit is ready for DMC playback operation. To start DMC playback, press the button again.

2-10

Chapter 2 Location and Function of Parts