Menu Function 8 Chapter
Page 4
Item |
| Setting | |
|
|
|
|
F1 (CAPSTN) |
| Selects the number of fields for capstan lock in playback. | |
|
| In 59.94i, 29.97PsF mode | |
| 2F: The capstan servo locks in units of 2 fields. | ||
|
| When playing back a tape that was recorded with composite source signals, a vertical shift in the video | |
|
| (H shift) occurs. (When setup menu item 712 is set to ON.) | |
| 4F: The capstan servo locks in units of 4 fields. | ||
|
| Even when playing back a tape that was recorded with composite source signals, no vertical shift in the | |
|
| video (H shift) occurs. You should set this menu item to this setting when continuity in video phase | |
|
| across edit points is required for composite signal playback or when carrying out A/B roll editing. | |
|
| In 50i, 25PsF mode | |
| 2F: The capstan servo locks in units of 2 fields. | ||
|
| When playing back a tape that was recorded with composite source signals, a vertical shift in the video | |
|
| (H shift) occurs. (When setup menu item 712 is set to ON.) | |
| 4F: The capstan servo locks in units of 4 fields. | ||
|
| When playing back a tape that was recorded with composite source signals, a vertical shift in the video | |
|
| (H shift) occurs. (When setup menu item 712 is set to ON.) | |
| 8F: The capstan servo locks in units of 8 fields. | ||
|
| Even when playing back a tape that was recorded with composite source signals, no vertical shift in the | |
|
| video (H shift) occurs. You should set this menu item to this setting when continuity in video phase | |
|
| across edit points is required for composite signal playback or when carrying out A/B roll editing. | |
|
|
| |
|
| Note |
|
|
| The setting is automatically fixed at 2F when operating in 24PsF or 23.98PsF mode, and this cannot be | |
|
| changed. | |
F3 (DOLBY) |
| When using oxide tapes, specifies whether or not to use the Dolby type C | |
|
| (NR) system. | |
| NR ON : Use the Dolby NR system when playing back analog Betacam oxide tapes. | ||
| NR OFF : Do not use the Dolby NR system when playing back analog Betacam oxide tapes. | ||
|
|
| |
F4 (CHARA) |
| Specifies whether or not to superimpose time code, menu settings, error messages, and so on over the | |
|
| video signals output to the HDSDI OUTPUT3(SUPER) connector, SDI OUTPUT3(SUPER) connector and | |
|
| COMPOSITE VIDEO OUTPUT3(SUPER) connector. | |
|
| ON: Superimpose. | |
|
| OFF: Do not superimpose. | |
|
|
| |
F5 (RECINH) |
| Specifies whether or not to inhibit recording shot marks to tape. | |
|
| ON: Inhibit recording to tape. | |
|
| OFF: Do not inhibit recording to tape. | |
|
|
|
|
Page 5
Item | Setting | |
|
|
|
F1 | Displays the | |
|
| For details of the |
|
|
|
F2 | (UMID) | Displays UMID information during playback. |
|
| For details of UMID, see Chapter 7. |