Sony HES-V1000 Saving Frequent, Procedures, Registering a MACRO, To exit the Learning mode, ePress RM SET UP to finish, To erase a learned function, Buttons, Functions

dAt close range (2–4 inches, about 5–10 cm) and facing the sensors on the server’s remote and the AV amplifier’s remote, send the remote code from the AV amplifier’s remote.

The device's button light pressed in step 2 (AMP) turns off. Keep sending for more than one second until the button flashes again.

eCheck that AMP flashes again.

Learning has failed if AMP flashes five times. If it flashes 10 times, the remote’s memory is full. Clear the remote’s memory (page 130) and repeat from step 1.

fPress RM SET UP again to exit the Learning mode.To exit the Learning mode

Press RM SET UP. Or, leave the remote for more than 60 seconds without operating.

To erase a learned function

Example: Erasing the function assigned to “1” above.

1 While holding down RM SET UP, press CLEAR.RM SET UP flashes twice.2 Press the device function button (AMP) to select the function to erase.AMP lights up and RM SET UP keeps flashing.3 Press the device selection button you want to clear (“1”).AMP flashes twice and the device selection function of “1” is cleared.If it fails, RM SET UP flashes five times.

zHint

See below when you want to clear the remote’s memory entirely.

To erase all learned functions1 While holding down VOL –, press \/1 and AV \/1 at the same time.RM SET UP flashes three times.2 Release VOL –.

Saving Frequent

Procedures

The MACRO function lets you register a sequential procedure that consists of up to 30 presses of the remote’s buttons.

This function is convenient, for example, when you have many devices in your home theater and need to press many buttons for many devices before you start viewing.

RM SET UP MACRO 1/2/3

	TV	SET
	TV	SAT/CABLE
	SERVER	AMP
	VCR	AMP
	VCR
	CUSTOM

HOME

Registering a MACRO

Note that the other devices need to be registered to the device selection buttons (TV, VCR, etc.,) beforehand (page 129).

aWhile pressing down RM SET UP, press MACRO 1/2/3 for more than one second.The RM SET UP flashes twice, and the pressed MACRO button lights up.

bPress the device selection button to switch the remote’s mode for the device (i.e., press TV to operate a TV).

The device selection button flashes.cSet the button operations by pressing the following function buttons.

Buttons	Functions
TV, VCR, AMP,	Switches the remote’s mode for the
SAT/CABLE,	device.
CUSTOM,
SERVER

MACRO1–3	Sets intervals before sending a signal
	when pressed for more than one second.
	(MACRO 1: 1 sec., MACRO 2: 5 sec.,
	MACRO 3: 10 sec.)

Other buttons	Sets the functions to perform.

dRepeat steps 2 to 3 to set the entire sequence.RM SET UP flashes twice and lights up again each time you press other buttons.ePress RM SET UP to finish.

130