Sony LIB-D81 Setting the SCSI ID

Setting the SCSI ID

Use the SCSI ID switches at the back of the AIT autoloader to set the AIT drive and/or AIT autoloader SCSI ID.

The default settings of the switches are as follows.

Use the upper switch to set the AIT drive SCSI ID and the lower switch to set the AIT autoloader SCSI ID.

AIT drive SCSI ID

	2	3
1
0

F
	E
		D
	2	3
1
0
F
	E
		D

4	5
	6
		7
			8
		A	9
C	B
4	5
	6
		7
			8
		A	9
C	B

AIT autoloader SCSI ID

Caution

•Do not set the same SCSI ID for the AIT drive and AIT autoloader.

•Make sure that you perform these settings before turning on the AIT autoloader.

1 Make sure that the power switch on the rear of the AIT autoloader is in the off position (a is depressed).

2 Use a pointed object such as a machinist’s screwdriver to turn the switches until their arrows match the setting that you want.

3 Press the power switch to turn on the power.

If you want to connect SCSI peripheral devices, see “Connecting SCSI Peripheral Devices” (page 22).

Chapter 2 Installation 21