Notes
1To begin cleaning the AIT drive, insert the cleaning cartridge in slot CL/8 and press the CLEAN button for at least three seconds.
2If you are unable to open the front door, it may be locked from your backup software.
3If the cartridge is not ejected from the AIT drive when an error occurs, proceed as follows.
1Press the DOOR button for at least five seconds.
The cartridge is forcibly ejected from the AIT drive and the front door unlocked.
2Restart the system.
3Restart the AIT autoloader.
4If [ 
] appears to be rotating or [E J] flashes on the display, then the loader is in operation. Depending on the state of the cartridge, it may take up to 20 minutes for it to be detected.
5Pressing the CLEAN and DOOR buttons simultaneously for at least five seconds starts Disaster recovery.
6In the code reference table, “XX” refers to an error code.
7Cleaning normally takes approximately one minute. If there is a cartridge in the AIT drive when you begin cleaning the drive, it is returned to its original slot before the cleaning procedure starts.
If you are writing to a damaged cartridge, unloading may take some time. For this reason, cleaning can take up to 20 minutes.
Appendix 54