The message display changes as follows and the startup process begins. (Startup takes several minutes.)

During startup, the following appears on the message display.

Moves gradually up and down during the elevator check.

Indicates the startup phase, from 0 to 3.

When startup is complete, the message display indicates the number of cartridges in the AIT autoloader.

Starting up

Startup complete

2 After pressing the standby switch on the autoloader’s front panel, wait at least 10 seconds before turning on the host computer.

Notes

•If you start the host computer before the autoloader, the SCSI ID is not detected correctly. Therefore, you must always start the autoloader before starting the host computer.

•If the autoloader does not work as above, see “Troubleshooting” (page 42).

Chapter 2 Installation

23