Turn Off the Power

Press the power switch on the rear of the AIT autoloader to turn it off.

Caution

Do not turn off the AIT autoloader when it is in use or there is a cartridge in the

AIT drive, as this could damage data.

Note

After turning the AIT autoloader off, wait at least 10 seconds before turning it on again.

Setting Cartridges

Prepare cartridges and insert them into the AIT autoloader.

Preparing Cartridges

Make sure that cartridges are not write-protected and prepare them for use.

Verify whether the write-protected tab is in the write-enable position. If the tab is orange, data can be written to a cartridge.

AIT-1

AIT-2, AIT-3

Lid

Lid

If the tab is moved to the left, data can be written to and erased from the cartridge.K

If the tab is moved to the right, data cannot be written or accidentally erased from the cartridge.k

If the tab is lowered, data can be written to and erased from the cartridge.j

If the tab is raised, data cannot be written to or accidentally erased from the cartridge.J

Chapter 2 Installation

24