Unit LCD display
XX XX AUDIO
Adjustment value
(The data can be changed/written when flashing.)
Mode No.
(Lower two digits are displayed.)
3.Press the keys below to change the mode number. ( : Increases the one place.
p : Sets the one place to 0.
This key brings the ten place to 0 if the one place is 0.
VOLUME + : Increases the ten place by 10 if the one place is 0. Increases the adjustment value if the one place is
VOLUME
• How to Adjust in the Audio Mode
1.When the audio mode is set to the appropriate mode for each adjustment, the lower tow digits of the mode No. and the value stored in EEPROM are displayed and flashing.
2.Change the adjustment value with VOLUME + or – key and press P key to write the new value to EEPROM.
• How to Check in the Audio Mode
The audio mode allows the checks below to be performed:
1.For the mode numbers of 111 to 113, 115 and 116, pressing P key will activate a beep. But for the mode number of 117, press- ing P key will not activate a beep. (No beep sounds when cHOLD switch is put on.)
2.For the mode numbers of 121 to 124, pressing Digital MEGA BASS key will display the DBB mode for the adjustment value.
1 : Mode 1
2 : Mode 2
13 : OFF
(This will not be accepted when the LINE OUT jack is plugged. The display will be 13 : OFF when LINE OUT jack is plugged in Modes 1 and 2.)
(3)Mechanism Mode
•How to Transfer the Mode in the Mechanism Mode:
Mode No. | Test Description | Operation |
200 | FUNCTION | Stepper control |
210 | MECHA test | Initial position return |
211 | HEAD adjustment | Operation variation changing (19) |
212 | REC position | Recording head descent |
220 | RESUME | Resume |
221 | RESUME CLEAR | Resume clear/initialization |
|
| ( ) : Default value |
1.Go into the test mode.
2.Press + or VOLUME + and VOLUME + and VOLUME
+in this turn to set the mechanism mode.
Unit LCD display
XX XX MECHA
Adjustment value
Mode No.
(Lower two digits are displayed.)
3. Press the keys below to change the mode No.
(: Increases the one place. p : Sets the one place to 0.
This key brings the ten place to 0 if the one place is 0.
VOLUME + : Increases the ten place by 10 if the one place is 0. Increases the adjustment value if the one place is
VOLUME
• How to Check in the Mechanism Mode
The mechanism mode allows the checks below to be performed:
1.For the mode numbers of 200, 210 to 212, 220 and 221, pressing
=key will move the optical pickup to the inner radius. Pressing + key will move the pickup to the outer radius.
2.For the mode numbers of 211 and 212, pressing P key will start aging. Pressing p key will stop aging.
•Mode No. 211 ... Sled aging with stepper at playback position.
•Mode No. 212 ... Sled aging with stepper at recording position.
3.With the mode number 210 selected, pressing P key will start aging with steeper at between home and recording positions. p key will stop aging.
– 14 –
