Overview 1 Chapter

STANDBY button: Press this button to put the unit into standby-off mode (the STOP button lights, and the STANDBY indicator lights). Press it again to return to the original state (STOP button lit, STANDBY indicator off).

This unit has a function that can put it into standby-off mode automatically after a certain length of time passes in disc stop mode. For details, see the explanation of STILL TIMER in the setup menu (page 83).

eTS REC (transport stream record) button

Press this button together with the PLAY button to start recording. Recording starts on the unrecorded part of the disc.

Press the STOP button to stop recording. A clip is created from the recorded section.

Note

This button is enabled when you record TS input signals (when the PDBK-102 MPEG-TS Input/Output Board is installed) or the signals of the internal signal generator.

Rear Panel

1Analog video signal output section

2Analog audio signal output section

COMPOSITE OUT

AUDIO MONITOR

-AC IN

 

 

R

L

POWER

 

 

 

 

 

 

 

3Power supply

 

AUDIO OUTPUT

 

section

1/3

2/4

 

 

MONITOR

RS232C

REMOTE(9P)

 

 

 

S400

4External device connection section

1Analog video signal output section

1COMPOSITE OUT connectors

COMPOSITE OUT

2 MONITOR connector

MONITOR

aCOMPOSITE OUT connectors (phono jack, BNC type)

These output composite video signals.

When CHAR SEL on the HOME page of the function menu is set to “ON” or “LCD” (see page 76), information such as timecode, menu settings, and error messages is superimposed on the output signals.

bMONITOR connector (D-sub 15-pin)

This outputs HD analog video signals. The output signals can be switched with INTERFACE SELECT >D-SUB OUTPUT in the setup menu (see page 85).

2Analog audio signal output section

1 AUDIO OUTPUT 1/3 and 2/4 connectors

2 AUDIO MONITOR connectors

AUDIO MONITOR

R L

AUDIO OUTPUT

1/32/4

18 Names and Functions of Parts