Playback and Recording 3 Chapter

2 To perform repeat playback for clip list playback, load a clip list into the current clip list and then press the SUB CLIP button.

3 Press the PLAY button.

Playback starts from the saved playback position. Normal playback: When playback of the last clip finishes, it resumes from the start of the disc,

repeatedly playing from the first through the last clip on the disc.

Clip list playback: When playback of the last sub clip finishes, it resumes from the start of the clip list, repeatedly playing from the first through the last sub clip in the clip list.

Repeat playback begins the unit is powered on if it is powered on with a disc loaded and OPERATIONAL FUNCTION >REPEAT MODE in the setup menu set to “ON”. Clip list playback starts from the first sub clip in the clip list.

To start repeat playback from the device connected to the REMOTE (9P) connector

Set OPERATIONAL FUNCTION >REPEAT MODE in the setup menu to “ON”, and then send the command to start repeat playback from the external device.

For details of commands, refer to the REMOTE (9-pin) Protocol Manual for the PDW series (not supplied).

To stop repeat playback

Do one of the following.

•Set OPERATIONAL FUNCTION >REPEAT MODE in the setup menu to “OFF”.

•Operate any of the playback buttons except the PLAY button, or operate the jog or shuttle dial.

•From the external device connected to the REMOTE (9P) connector on this unit, send a command other than the repeat playback start command to this unit.

Note

The unit enters search mode when you conduct a search, and stop mode at the end of the disc.

Locking (Write-protecting) Clips

In the thumbnail screen, you can lock them so that they cannot be deleted or altered.

Locking prevents the following operations on clips.

•Deletion

•Renaming by FAM or FTP

•Changing the thumbnail image (index picture)

•Adding and deleting shot marks

Notes

•Locked clips are deleted along with other clips.

•Clips cannot be locked or unlocked when the Write Inhibit tab of the disc is set to the recording disabled position, or when “REC INH” on the HOME page of the function menu is set to “ON”.

1 With the SUB CLIP button off, press the THUMBNAIL button, turning it on.

The thumbnails of the clips on the disc appear.

2 Select the clip to lock (you can do this with the same operations as step 1 of “To select a thumbnail image and start playback” (see page 43)).

Clip to be locked

3 Press the MENU button.

The CLIP menu appears.

4 Use the V/MARK1 or v/MARK2 button to select “LOCK/UNLOCK CLIP”, and then press the SET button.

A lock confirmation screen appears. This screen displays clip names and clip titles.

To cancel the lock operation and return to the THUMBNAIL screen

Select “CANCEL”, and then press the SET button. Press the RESET or MENU button.

5 With OK selected, press the SET button.

48 Playback