Full salvage: Clips are reconstructed on the basis of

2 Press the SET button.

markers recorded on the disc. Nonvolatile memory

Processing begins and the message “Executing.”

cannot be used, so processing takes longer than for a

appears.

quick salvage (about 30 seconds, although it depends

When processing finishes, a message appears to

on the state of the disc).

display the results.

You are prompted to execute a full salvage whenever

If the message reads “Incomplete!”, the clips that

you insert a disc that was removed manually from a

failed were lost.

powered off device after interruption of recording by

 

power off.

 

Note that no recorded clip contents are lost when the on/

 

standby switch on the front panel is set to standby during

 

recording, because the unit does not enter standby mode

 

until after the end of recording processing.

 

Notes

•Even after recording finishes, do not set the POWER switch on the rear panel to off until the ACCESS indicator has gone out.

•These functions salvage as much recorded material as possible after an unforeseen accident, but 100% restoration cannot be guaranteed.

•Even when these functions are used, it is not possible to recover data from immediately before the interruption of recording. The amount of data lost is as follows.

Quick salvage: From 2 to 4 seconds of data before the interruption of recording.

Full salvage: From 4 to 6 seconds of data before the interruption of recording.

•You are prompted to execute a full salvage every time you insert a disc that has not been salvaged, or power the unit on with such as disc loaded.

•No recording is possible on discs containing clips that have not been salvaged, although it is possible to play back the normally recorded sections. Recording becomes possible if you perform a quick format, but this erases all of the original recorded content.

To restore clips with a full salvage

1 Insert the disc on which recording did not end normally.

The message “Salvage ?” appears on the display.

To cancel the clip salvage

Press the RESET button.

Notes

•The message “EJECT?” appears when “REC INH” is displayed in the operation modes section of the display. If the disc is write protected, eject the disc, set the Write Inhibit tab to enable recording, and then insert the disc again.

•This operation cannot be cancelled once it begins.

Playback and Recording 3 Chapter

Handling Discs 37