Sony PDW-F30 Editing Control Unit Settings, Remote Control Unit Settings, BVE-700/700A

SD video monitor

To composite video input connector

To analog audio input connector

12

	COMPOSITE		AUDIO	PDW-F30 (this unit, player)
	OUT		MONITOR
	COMPOSITE OUT	AUDIO MONITOR		-AC IN
		R L			POWER
2Chapter
		AUDIO OUTPUT
	1/3	2/4
Preparations		MONITOR	RS232C	REMOTE(9P)		S400
				S400		4

DSR-2000A/2000AP (recorder)

i.LINK

VIDEO OUT 3
			MONITOR
(SUPER)	1		AUDIO
To composite		3
video input
connector

To analog audio input connector

SD video monitor

1: 75Ω coaxial cable (not supplied)

2: Phono plug – stereo miniplug cable (not supplied)

3: Phono plug cable (not supplied)

4: i.LINK cable (not supplied)

DSR-2000A/2000AP	This unit’s (player) settings
(recorder) settings
i.LINK button: Lit	Remote control switch:
	REMOTE
SDTI/i.LINK button: i.LINK	Set the setup menu item
	INTERFACE SELECT
	>REMOTE I/F to “i.LINK” (see
	page 85).

For details about the settings of the DSR-2000A/2000AP, refer to the operating instructions for that unit.

Editing Control Unit Settings

When connecting an editing control unit to use with this unit, make the following settings.

BVE-700/700A

Set VTR constants as follows.

System	VTR CONSTANT 1
frequency
	1	2	3	4	5	6	7	8
30P/60I	A0	94	00	96	16	16	03	80
25P/50I	A1	94	00	7D	16	16	03	80
24P	A2	94	00	78	16	16	03	80

System	VTR CONSTANT 2
frequency
	1	2	3	4	5	6	7	8
30P/60I	0A	07	FE	00	80	5A	FF	5A
25P/50I	0A	07	FE	00	80	4C	FF	4B
24P	0A	07	FE	00	80	48	FF	48

Remote Control Unit Settings

You can control this unit from an RM-280 Remote Control Unit.

Connect this unit to the RM-280 with a 9-pin remote control cable (not supplied), and make the settings in the following table.

RM-280 settings	Settings on this unit
EDITOR/REMOTE	Setup menu item INTERFACE
CONTROL:	SELECT >REMOTE I/F (see
REMOTE	page 85): 9PIN/RS-232C
CONTROL
Setup menu item 19	Remote control switch: REMOTE
FNC MODE:
	Remote connector selector
XDCAM
	switch: REMOTE(9P)

26 Connections and Settings