Notes
•If video or audio signals from an external device connected to the S400 connector fail to be output,
disconnect the i.LINK cable and connect it again, pushing it straight in.
Chapter | • Before connecting or disconnecting an i.LINK cable | |
connector, power off the device and disconnect its power | ||
| between this unit and a device with a | |
1 | cord from the electrical outlet. If the i.LINK cable is | |
Overview | ||
connected or disconnected with the device’s power plug | ||
| ||
| still connected, high voltage (8 to 40 V) from the | |
| device’s i.LINK connector can flow into this unit, | |
| possibly damaging the unit. | |
| • When connecting this unit to a device with a | |
| i.LINK connector, connect to the | |
| connector of the other device first. | |
| • Except in playback modes (jog and shuttle modes, etc.), | |
| audio signals output from this connector and monitored | |
| on another device may sound different from the audio | |
| signals played back on this unit. | |
| e U (signal ground) terminal | |
| Connect to the system ground. |
Infrared Remote Commander
The corresponding functions are executed when you point the remote commander at the infrared sensor of the main unit and press the keys and setting pad.
If you want to disable control of this unit from the remote commander, set INTERFACE SELECT >WIRELESS RMT in the setup menu to “DISABLE” (see page 86).
1Setting pad
2 THUMBNAIL key | PUSH SET |
| |
| THUMBNAIL SUB CLIP |
3 CHARACTER key | CHARACTER |
4SUB CLIP key
PREV PLAY NEXT STOP
5Recording/playback
control keys | SEARCH |
6SEARCH keys
aSetting pad
Positions on the pad correspond to functions of the main unit, as follows.
Press the top side: M/MARK1 button
Press the bottom side: m/MARK2 button
Press the left side: </IN button
Press the right side: ,/OUT button
Press the middle: SET button
bTHUMBNAIL key
This has the same function as the THUMBNAIL button on the main unit.
cCHARACTER key
Each press of this key turns the character information superimposed on the monitor screen on and off, or switches to the LCD.
dSUB CLIP key
This has the same function as the SUB CLIP button on the main unit.
Note
Pressing this key has no effect when no clip list is registered.
eRecording/playback control keys
PREV (previous) key: Press this to jump to the first frame of the current clip. When pressed at the first frame of the current clip, this button jumps to the first frame of the previous clip.
PLAY key: Press this to start playback. Press the STOP key to stop playback.
NEXT key: Press this to jump to the first frame of the next clip.
STOP key: Press this to stop recording or playback.
fSEARCH keys
Press m to perform
Press M to perform +5 times normal speed shuttle playback in the forward direction.
Using the infrared remote commanderBefore use
Pull out the insulation sheet.
Insulation sheet
To replace the lithium battery in the remote commander
The remote commander uses a CR2025 Lithium Battery. Do not use a battery other than the CR2025.
1 Hold down the lock lever 1, and then pull out the battery holder 2.
20 Names and Functions of Parts