Recording TV programmes using the G-Code system

The G-Code system is a feature that simplifies setting the timer. Just enter the G- Code programming number listed in the TV programme guide. The date, time, and programme position of that programme are set automatically.

Check that the programme positions are correctly set in “Channel Setting” in the “Basic” setup (page 68).

3 Press the number buttons to enter the G-Code programming number, and press ENTER.

The date, start and stop times, programme position, recording mode, etc. setting (page 37) appear.

•If you make a mistake before pressing ENTER, press </, and re-enter the correct number.

Recording Timer

Number buttons

TIMER

</M/m/,,

ENTER

z REC

x REC STOP

1 Press TIMER.

2 Select “G-Code No.” using M/m, and press ENTER.

•If you want to change the setting, press </, to select the item and press M/m to change the setting.

•If you want to re-enter the G-Code programming number, select “G-Code No.,” and press ENTER. Then re-enter the G-Code programming number.

4 Select “OK,” and press ENTER.

The TIMER REC indicator lights up on the front panel, and the recorder is ready to start recording.

To stop recording during timer recording

Press x REC STOP.

Note that it may take a few seconds for the recorder to stop recording.

If the timer settings overlap

See page 38.

To extend the recording duration time while recording

See page 38.

To confirm, change, or cancel a timer recording

See “Checking/Changing/Cancelling Timer Settings (Timer List)” on page 41.

zHint

The Rec Mode Adjust function also works with this timer method (page 38).

,continued 39