The programme position cannot be changed from the programme position you are recording.
,Set the TV’s input source to “TV.”
Recording does not start immediately after you press z REC.
,Operate the recorder only after “LOAD,” “FORMAT,” or “INFOWRITE” disappears from the front panel display.
Nothing was recorded even though you set the timer setting correctly.
,There was a power failure during recording.
,The recorder’s internal clock stopped due to a power failure that lasted for more than 1 hour. Reset the clock (page 72).
,The channel was disabled after the timer recording was set. See “Channel Setting” on page 68.
,Disconnect the AC power cord (mains lead) from the mains, and connect it again.
,The programme contains copy protection signals that restrict copying.
,Other timer setting overlapped the timer setting (page 42).
,There is no DVD inside the recorder.
,There is not enough disc space for the recording.
,The recorder was in the process of DV Dubbing.
Recording does not stop immediately after you press x REC STOP.
,It will take a few seconds for the recorder to input disc data before recording can stop.
Recording does not stop after you press x.
,Press x REC STOP.
Timer recording is not complete or did not start from the beginning.
,There was a power failure during recording. If the power recovers when there is a timer recording, the recorder resumes recording. Should the power failure continue for more than 1 hour, reset the clock (page 72).
,Other timer setting overlapped the timer setting (page 42).
,Disc space was not enough.
Contents previously recorded were erased.
,Data that is not playable on this recorder but was recorded on a DVD with a PC will be erased from the disc when the disc is inserted.
Recording from the equipment with a timerNothing was recorded even though you set the
,You forgot to turn off the connected equipment. Turn off the connected equipment and set the recorder to Synchro- Rec standby mode (page 43).
,The recorder was not set to the Synchro- Recording standby mode. Press
c z SYNCHRO REC to have the recorder stand by for recording. Make sure the SYNCHRO REC indicator lights up on the front panel (page 43).
,The equipment is not connected to the LINE 1 IN jacks of the recorder.
,The recorder is connected to the TV output jack of the connected equipment.
,The timer setting for the connected equipment overlapped the recorder’s timer setting (page 44).
,There was a power failure during the recording.
The recorder automatically starts recording when the satellite receiver is turned on.
,The
Information Additional
,continued 85