Performing Several
Commands in Sequence
Automatically (Macro Play)
The Macro Play function lets you link several IR codes in sequential order as a single command. The remote provides 3 macro lists (MACRO 1, 2 and 3). You can specify up to 10 IR commands for each macro list.
1 Touch FUNCTION.
| The FUNCTION screen appears. | ||
| 2 Touch . |
| |
|
| ||
Operation |
| ||
The MACRO screen appears. | |||
| |||
| When | does not appear in the FUNCTION screen, | |
use the JOG DIAL to scroll through the list until it is displayed, and then touch it.
• Touch SEND to operate Macro Play. The current command is displayed in black. The finished commands are grayed out.
Changing receiver settings
You can set the receiver’s audio input, or change the brightness of the display.
1Touch FUNCTION.
The FUNCTION screen appears.
2Touch 
.
The CUSTOMIZE screen appears.
When 
does not appear in the FUNCTION screen, use the JOG DIAL to scroll through the list until it is
displayed, and then touch it.
BOX Number
Command
Send key
Condition
•To change the audio input of the function which is not currently selected, touch FUNCTION.
•To change the audio input of the current function, touch
AUDIO SPLIT.
•To change the INPUT MODE of the current audio input, touch AUDIO INPUT.
•To adjust the brightness of the display, touch DISPLAY DIMMER.
3Press the 
button or the 
button repeatedly until the desired setting appears.
Category Now Sending: Outputting the command Done!: Outputting is finished
•To cancel Macro Play, touch CANCEL. When Macro Play is not operating, touching CANCEL returns to the FUNCTION screen.
Notes
•For some models, the receiver cannot operate the Macro Play commands as the time between each command is too short. In this case, set “WAIT TIME” between each command. To set “WAIT TIME”, refer to “Macro Play setting” on page 25 and 26.
•For some makers other than Sony, there are some commands that cannot be used in Macro Play.
16