1 m ~ 2 m

Notes

•To ensure good communication conditions, carry out initial setup from directly in front of, and close to the receiver.

•Do not move the unit during initial setup.

If a communication error occurs during setup

An error message will be displayed.

•Touching OK will return to the step 5 setup screen.

•Touching SKIP goes to the regular screen without carrying out initial setup. Although operation is possible in this condition, functions not included on the receiver will be displayed, and some buttons will not be operable. Also, the initial setup screen will appear each time the touch panel is turned on.

Note

The commander receives and displays data transmitted from the receiver. Communication errors may occur if the commander’s transmitter/receiver section is not directed properly toward the receiver’s display.

Be sure to point the commander’s transmitter/receiver section towards the receiver’s display.

When replacing the batteries

When to replace batteries

Preparations

To ensure preservation of the commander’s internal

 

memory when replacing batteries, be sure to observe the

 

following cautions.

 

When the batteries become weak, a warning sounds and a

 

message is displayed. Replace batteries as instructed by

 

the message.

 

Replace alkaline

Replace lithium

batteries.

battery.

How to remove the lithium battery

Notes

•Disc titles and song titles downloaded from the CD changer are memorized in the commander. The lithium battery is used for preservation of this memory. If the unit is used with an exhausted battery, the settings memorized in the commander will be erased. Please replace the battery as soon as the “Battery Low” message appears.

•Replace the alkaline batteries with new batteries as soon as their charge is exhausted. If the unit is used with exhausted batteries, exhaustion of the lithium battery used to maintain memory will be quickened and the memorized settings may be erased.

•The life span of batteries may be shortened depending on the conditions in which the commander is used.

•If the alkaline batteries and lithium battery become exhausted at the same time, replace the alkaline batteries first. Replacing the lithium battery first will erase the data memorized in the commander.

•When replacing the alkaline batteries, always replace all 4 batteries with new ones.

•After replacing batteries, be sure to carry out touch panel adjustment (page 6).

7