Adjusting the Commander’s Operating Environment

Operation

6Point the remote code receiver section of the commander toward the receiver/transmitter on the remote control to be learned.

About 5 cm ~ 15 cm

7Press the appropriate button on the remote control to send the remote control code.

Lightly pressing the button once should be sufficient. In about 3 to 5 seconds, it is displayed whether learning was successful or not.

When learning is successful, “Learning OK!” is displayed, and a mark (■) will appear next to the selected box.

When learning is not successful, “Learning Fail..” is displayed, and 3 seconds later “Please Send Signal” is displayed again. Please do this procedure again from step 6.

To erase the learned code

After step 7, touch “Clear” and the display changes to “Clear?”. If “Yes” is touched at this time, the newly learned code is erased. If “No” is touched, the code is not erased, and the commander returns to its previous condition.

zYou can test the learned code

Touch “TEST” after “Learning OK” is displayed in step 7. The learned code is sent from the commander, and if correct, the operation corresponding to the learned code is performed.

zYou can make a name of up to 14 characters for the learned code

Touch name input buttons as displayed in step 4 to enter the name.

Notes

•Normally, in the areas from A to J, there is a total of 80 BOX Numbers that can be used with the Learning function. However, depending on the signals of the codes being learned, it may not be possible for the commander to store codes for all 80 BOX Numbers.

•To learn commands such as volume, fast-forward, rewind (etc.) that are generally performed by continuously pressing the button, press and hold the button until “Learning OK” appears in step 7. For other commands such as play, pause, and stop (etc.) where continuously holding the button is not necessary, learning is usually possible by pressing the button once.

•Some remote control codes cannot be learned.

28