Preparations
Preparing the Commander
Setting up the commander
Please be sure to carry out the following 5 steps for preparation of the commander.
The commander’s panel is touch sensitive and can be operated by simply touching it.
1Remove the touch pen.
When returning the touch pen, always slide it in tip first.
Pen holder
Remove by sliding out
Touch panel adjustment
3Adjust the position of the touch panel’s LCD.
Touch the center of each of the 4 dots with the touch pen. When all 4 dots have been touched “Adjusted” appears, a buzzer sounds, and the initial communication screen appears.
Touch the 4 dots with the touch pen.
Caution
Use only the touch pen provided with this unit or the soft tip of your finger to operate the touch panel. Using a commercially available writing utensil may damage the panel and make correct operation impossible. If the tip of the touch pen is damaged, or the touch pen is lost, please consult your nearest Sony dealer.
2Turn CONTRAST to adjust brightness of the LCD.
CONTRAST control
Caution
Touch panel adjustment must be carried out for proper panel operation. If used without adjustment, the ”Touch Panel Adjustment” screen appears each time the LCD lights up.
Initial communication
4Press 1/uon the receiver to turn on the receiver.
5Point the commander’s transmitter/receiver section toward the receiver’s display, and touch OK.
Once initial communication with the receiver has been established, the commander is ready to operate the receiver.
6