Registering the connected components
The following procedure lets you set up the commander to operate the components connected to the receiver.
When carrying out this operation, make sure that the receiver’s power is on, and be sure to point the commander’s transmitter/ receiver section toward the display on the receiver.
1Touch SETUP.
The SETUP screen appears.
2Touch FUNCTION&USER IR.
The FUNCTION&USER IR screen appears.
3Select the function that you wish to register (Ex: VIDEO1).
To display other items, use the JOG DIAL or touch 4 or $to scroll through the list.
The FUNCTION&USER IR:CATEGORY screen appears.
4Select the type of component connected (Ex: VCR).
To display other items, use the JOG DIAL or touch 4 or $to scroll through the list.
The FUNCTION&USER IR: MAKER CODE screen appears.
Operation
5Touch the remote controller mode of the connected component (Ex: Sony VTR1).
The component selected in steps 4 to 5 will be registered at the function selected in step 3, and the FUNCTION&USER IR screen reappears. A long beep sound is emitted to indicate that registration was successful. Operation is now possible from the FUNCTION screen.
If a series of short beeps is emitted, redo the registration procedure. If this occurs, make sure the receiver is turned on and that the commander is pointing toward the receiver during operation.
To stop registration at any time
Touch EXIT during step 3 or touch CANCEL during steps 4 to 5.
Notes
•All icons may not be displayed when registering components made by certain manufacturers.
•Some commands may not function even though they are displayed when registering components made by certain manufacturers.
23