Preparing the Commander

Please be sure to carry out the procedures described in “Setting up the commander” on page 6 after inserting the batteries.

Inserting batteries into the commander

Insert the four size-AA (LR6) alkaline batteries (for commander operation) and the lithium battery (for preservation of the commander’s internal memory).

1Remove the battery compartment cover.

Push in direction of arrow

2Insert the alkaline batteries.

Size-AA alkaline batteries

 

]

 

 

}

}

]

 

] }

 

 

}

 

 

 

]

Always insert the negative (–) pole side of batteries first.

3Insert the lithium battery.

After wiping the lithium battery thoroughly with a dry cloth, insert it into the compartment with the positive (+) pole side facing up.

Coin shaped lithium battery CR2032

Positive (+) pole side up

4 Close the battery compartment cover.

Preparations

After inserting the batteries, touching the touch panel turns on the light and displays the touch panel (LCD) adjustment screen. Follow the procedure on the next page for touch panel adjustment and initial communication.

zYou can also use an AC power adapter (not supplied) instead of the four alkaline batteries.

Connect an AC power adapter (DC 300 mA minimum, 6V) (not supplied) to the DC input jack on the remote commander (see 7 on page 10).

Polarity of the plug

Note!

Be sure to insert the plug of the AC power adapter fully into the DC input jack.

If the plug of the AC power adapter is fully inserted, there may be no problem when you also use batteries. However, if the plug is not fully inserted and the batteries are also used, it may cause a malfunction depending on the adapter (or depending on the plug if the tip is not insulated).

When you are going to use the AC power adapter only for a long time, it is recommended to remove alkaline batteries. We recommend the use of Sony AC-E60HG (AC power adapter).

Notes

The LCD lights up when touched. The LCD also lights up when BACK LIGHT/COMMANDER OFF button is pressed.

VOL +/–, MUTING and SLEEP can be used even when the LCD is not lit.

Pressing BACK LIGHT/COMMANDER OFF turns the backlight on or off. Holding it down for about 2 seconds turns the LCD off.

If the commander is not used for 10 seconds, the LCD turns off automatically (Auto Off function). The Auto Off function can

be changed between 10 and 30 seconds under “Setting the LCD to turn off automatically” in the SETUP screen (see page 29). 5