Sony SDM-N80 Specifications, Self-diagnosisfunction, If the, LCD panel, Horizontal:, and then on, blank and the, off and then on, Input signal format

Self-diagnosis function

Specifications

This monitor is equipped with a self-diagnosis function. If there is
		LCD panel	Panel type: a-Si TFT Active Matrix
a problem with your monitor or computer(s), the screen will go			Picture size: 18.1 inch (46 cm)
blank and the1 (power) indicator will either light up green or
flash orange1(power). If the indicator is lit in orange,Input signal formatthe			RGB operating frequency*
computer is in power saving mode. Try pressing any key onHorizontal:the				28– 92 kHz**
keyboard or moving the mouse.			Vertical: 48 – 85 Hz**
		Resolution**	Horizontal: Max.1280 dots
			Vertical: Max.1024 lines
		Video input connector	Analog RGB: HD15
			Digital/analog RGB: DVI-I 29 pins
		Input signal levels	Analog RGB video signal
			0.700 Vp-p, 75 Ω , ποσιτιϖε
			ΣΨΝΧ σιγναλ
			ΤΤΛ λεϖελ, 2Ωκ,
			ποσιτιϖε ορ νεγατιϖε
			(Σεπαρατε ηοριζονταλ ανδ ϖερτιχαλ,
			ορ χο∝ποσιτε σψνχ)
	1 (power)		0.3 ςπ−π, 75 Ω , νεγατιϖε
	indicator		(Σψνχ ον γρεεν)
			Διγιταλ ΡΓΒ (ΔςΙ) ϖιδεο σιγναλ
			ΤΜΔΣ (Σινγλε λινκ)
If the 1 (power) indicator is green		Αυδιο ουτπυτ	1 Ω⋅ 2
		Ηεαδπηονεσ ϕαχκ	Στερεο ∝ινιϕαχκ
1 Turn off the AC power switch and disconnect the			Αχχεπτσ ι∝πεδανχε οφ 16– 48 Ω
		ΑΥΔΙΟ ΙΝ ϕαχκσ	Στερεο ∝ινιϕαχκ⋅ 2
video signal cables from the INPUT1 and INPUT2
			Αχχεπτσ ι∝πεδανχε οφ 47Ω κ
connectors of the media engine.
			Αχχεπτσ λεϖελ 0.5 ςρ∝σ
2 Press the AC power switch twice to turn the monitor		Ποωερ ρεθυιρε∝εντσ	100– 240 V, 50 – 60 Hz, 0.7 – 0.4 A
		Power consumption	Max. 67 W
off and then on.
		Operating temperature	5 – 35 °C
		Dimensions (w/h/d)	Display (upright and in the lowest
If all four color bars appear (white, red, green, blue), the monitor			position):
is working properly. Reconnect the video input cables and check
			Approx. 432 ⋅ 400 ⋅ 195 ∝∝
the condition of your computer(s).
			(17 1/8 ⋅	15 3/4 ⋅ 7 3/4 ινχηεσ)
If the color bars do not appear, there is a potential monitor failure.			Μεδια ενγινε:
			Αππροξ. 94⋅ 212 ⋅ 204 ∝∝
Inform your authorized Sony dealer of the monitor’s condition.
			(3 3/4 ⋅ 8 3/8 ⋅ 8 1/8 ινχηεσ)
		Μασσ	Δισπλαψ:
If the 1 (power) indicator is flashing orange			Αππροξ. 6.5 κγ (14 λβ 5 οζ)
			Μεδια ενγινε:
Press the 1 (power) switch twice to turn the display off			Αππροξ. 1.5 κγ (3 λβ 5 οζ)
		Πλυγ & Πλαψ	ΔΔΧ2Β
and then on.
		Αχχεσσοριεσ	Σεε παγε 7.
If the1(power) indicator lights up green, the monitor is working

properly.	∗ Ρεχο∝∝ενδεδ ηοριζονταλ ανδ ϖερτιχαλ τι∝ινγ χονδιτιον
	• Horizontal sync width duty should be more than 4.8% of total
If the1 (power) indicator is still flashing, there is a potential
	horizontal time or 0.8 µs, whichever is larger.
monitor failure. Count the number of seconds between orange
	• Horizontal blanking width should be more than 2.5 µsec.
flashes1of(power)the indicator and inform your authorized
Sony dealer of the’s conditionmonitor. Be sure to note the model	• Vertical blanking width should be more than 450 µsec.
	**A 1600 ⋅ 1200 ρεσολυτιον σιγναλ ισ δισπλαψεδ προϖισιοναλλψ ασ
name and serial number of your monitor. Also note the make and
	λονγ ασ ιτσ ηοριζονταλ ανδ ϖερτιχαλ φρεθυενχιεσ αρε λοωερ τηαν
model of your computer and graphics board.
	τηε φολλοωινγ ϖαλυεσ.
	• Analog RGB signal: Horizontal 107 kHz, Vertical 85 Hz
	• Digital RGB signal: Horizontal 75 kHz, Vertical 60 Hz
	Design and specifications are subject to change without notice.

26