Sony SDM-N80 Step 4: Connect the audio cord, Step 5: Connect the power cord, Step 6: Turn on the monitor and computer, Step 3: Connect the display and media engine

Step 3: Connect the display and media engine

Turn off the display and media engine before connecting them. To connect the system connecting cable to the display easily, set the display in an upright position.

A

to SYSTEM CONNECTOR of the display

System connecting cable (2 m) (supplied)

A

to SYSTEM CONNECTOR of the media engine

Align the v on the plugs with the von the display and the media engine.

Caution

Be sure to install the media engine vertically as shown above. Installing the media engine lying flat may block ventilation, and may cause a malfunction.

Note

When connecting the cable, grasp the plug and insert it firmly into the connector until you hear it click. When disconnecting the cable, pull out the plug while holding down locking lever A.

Step 4: Connect the audio cord

to AUDIO IN jack among the INPUT2 connectors

to an audio output jack on your computer

Audio cord (supplied)

Step 5: Connect the power cord

With the media engine, display, and computer switched off, first connect the power cord to the media engine, then connect it to a power outlet.

to AC IN connector

to a power outlet

Power cord (supplied)

Step 6: Turn on the monitor and computer1Turn on the media engine.

The display automatically turns on. The indicators of the media engine and display light up in green.

2 Turn on the computer.

Note

If you turn off the media engine and turn it on again while the display is off, the display will not turn on automatically. In this case, press the 1 (power) switch on the display to turn it on.

8