Location and Functions of Parts and Controls

The figure shows the camera without the dome casing and slit cover.

Side

7

8

T

W

N

 

9

1

2

3

4

5

6

a24V AC/12V DC (power input) cable

Connect to a 24V AC or 12V DC power supply system.

bBNC cable
dTilt angle adjustment screw

Loosen this screw before adjusting the lens position, and tighten it to fix the lens position.

eZoom lever

Outputs a composite video signal. Connect to a composite video input connector of a video monitor, VCR, etc.

cConduit holes (3/4 inch)

Connect a pipe to this hole. There are two conduit holes on the unit casing, one on the side and one at the bottom. The cover plug is installed in the side conduit hole at the factory. Remove the plug as needed and connect the pipe to the hole.

Move this lever to adjust the field of view. As the lever itself is a screw, tighten it to fix its position.

fFocus lever

Move this lever to adjust the focus. As the lever itself is a screw, tighten it to fix its position.

gAudio cable

The connector with the longer cable is used for the line output connector, and the other cable is used for the microphone input connector.

GB 10 Location and Functions of Parts and Controls